Danuser SM40 Hammer Bedienungsanleitung PDF herunterladen (Seite 15)

Troubleshooting

PROBLEM POSSIBLE CAUSE SOLUTION

Floating anvil falls out

or gets jammed

a. Weight is not down after

driving

When nished driving, make sure

weight is down and/or catch is visible

through viewing slots. Refer to

Operation section of manual.

b. Post too small Use T-post adapter when driving

small posts.

Weight is dropping

unexpectedly

a. Weight is not down after

driving

When nished driving, make sure

weight is down and/or catch is visible

through viewing slots. Refer to

Operation section of manual.

Vehicle battery is dead a. Tilt switch was activated

too long

Deactivate tilt switch when Hammer

is not in use.

Weight not cycling a. No post loaded in

Hammer

A post must be pushed up inside the

Hammer until it stops before the

weight will cycle.

b. Broken or missing shaft

key

Replace key.

c. Channel is not lubricated Grease the inside of the Hammer case.

d. Motor damaged Contact Danuser.

Motor will not operate a. Motor damaged Contact Danuser.

b. Incorrect hose routing Refer to Hydraulics section of manual

for proper hose routing.

Chain jumps a. Incorrect chain tension Adjust chain tension.

b. Sprockets or chain are

worn

Replace worn item(s).

Oil over heating a. High ow activated Ensure vehicle is not in high ow

mode.

b. Low oil level Fill reservoir to proper level.

c. Dirty oil or oil lter Change oil and lter.

Tilt feature not

working

a. No power to solenoid Check electrical connections. Ensure

switch is activated.

b. Blown fuse Check inline fuse in electrical

harness. Check vehicle's fuses.

c. Solenoid not working Contact Danuser.

d. Tilt lock pin in place Remove tilt lock pin. Refer to

Operation section of manual.

Tilt or grapple

cylinder not working

a. Air in hydraulic system Cycle hydraulics until both cylinders

have completely extended and

retracted (fully cycled).

b. Incorrect hose routing Refer to Hydraulics section of manual

for proper hose routing.

c. Tilt or Grapple

obstruction

Ensure tilt and grapple mechanisms

can move freely.

d. Cylinder damaged Contact Danuser.

For additional assistance, please call your dealer or contact Danuser direct:

Phone: (573) 642-2246

Fax: (573) 642-2240

E-mail: sales@danuser.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

Danuser SM40 Hammer Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Danuser SM40 Hammer